The correct operation and use of walking shaft driven pastoral management machine (2)

4. The actuating force should change with the operating conditions. The size and direction of the actuating force acting on the handrail frame depends on the farming conditions, such as upward movement, downward pressure, forward and backward pushing or pulling, and other changes. Press down deep and plow till it goes deeper. If the soil is too loose, the reaction force of the soil to the rotary knife will be too small, and the management opportunity will not be able to advance in the “grave pit”. At this time, it needs to be slightly lifted and pushed forward. Conversely, if the soil is very hard, press down forcefully; when the forward speed is too fast, pull it back at the same time. In actual farming, the operator must change the “feeling” and operation status, or push and lift the belt, or pull it together, or use a lot of force, or use less force, and the combination can be described as ever-changing. This is a "knowledge easy to do" technology, you need to gradually accumulate experience in order to be handy. 5, turning the head and turn the operation of the head turned by hand to push and pull the armrest frame, the body to follow up the method to complete the operation is not skilled, you should first slow down the throttle, and then lift up and turn up, sometimes in front of obstacles or turn head distance is insufficient , Can be used to pull back the management machine to turn around 6 and determine the number of tillage times. The maximum tillage depth of the management machine can reach more than 20cm, but it needs to be cultivated several times to achieve. The number of tillage passes is selected based on soil conditions and planting requirements for lower crops. The more you plow, the deeper you plow, and the dirt becomes. However, the area of ​​work is reduced. After most of the plots are cultivated for 3 to 5 times, the agronomic requirements can be achieved by operating indexes such as soil fraction, tillage depth, and stubble coverage. In order to prevent the soil from being compacted and keep the ground flat, the foot should be stepped on the uncultivated land or sulcus during the last cultivation. 7. For the plots with a height of more than 20cm in a special plot tillage or crops, the grass cannot be normally cultivated due to the rotary knife axis, and it is necessary to remove the wrapped grass on the cutter shaft with a guillotine blade in time to operate normally. Soil that is harder and the rotary tilling knife is not easy to get into the soil will be required for the first time as long as it is able to enter the surface and plough the field surface. It does not require and cannot meet agronomic requirements. Greenhouse facilities collide. The field blocks that have already been completed should be shoveled into the earthworms and then tilled. After ploughing and shoveling, manual smashing will be required, which will take time and effort. When turning the head, it is necessary to prevent the unilateral falling of the rotary ploughing components from falling into the sulcus to cause turning over. In fields where obstacles such as stones and tree roots are cultivated, the hand will feel when it comes to obstacles. At this time, it is necessary to stop in time and remove obstacles before operating.

Red PVC Coated Gloves

Red Pvc Coated Gloves,Red Coated Industrial Gloves,30Cm Pvc Red Gloves,Red Pvc Fully Coated Gloves

JINAN SHANDE SECURITY TECHNOLOGY CO., LTD , https://www.sdsxlb.com