Horizontal trough mixer instructions and maintenance

1. Before use, perform a dry run test. Before the test, check the firmness of all the connecting parts of the horizontal trough mixer, the amount of lubricating oil in the reducer and the integrity of the electrical equipment, and then close the main switch. Pass the power supply and test the air run.

2. The empty running test requires an item-by-item test. It can only be put into production if no abnormal sounds, high heat of the bearing, high temperature of the reducer, etc. are found.

3. If you need to shovel the material of the tank wall during operation, apply bamboo and wood tools, and do not use your hands to avoid accidents.

4. If the machine vibration is abnormal or abnormal noise is detected during the use of the horizontal trough mixer, stop it immediately.

5. The load of the mixer should not be too large. Generally, it is measured by the load of the motor. The heavy load current when mixing with a 380V motor is not more than 6 amps. If the load exceeds the load, the mixing capacity should be reduced immediately.

6. The shaft seals at both ends of the mixing paddle should be kept clean to avoid blackening and deterioration of the material. The square holes at the two ends of the mixing tank should be open, and should not be blocked, so as to prevent back pressure and allow dirt to penetrate. The shaft center makes the material in the tank black and deteriorate.

7. Managers must be familiar with the technical performance, internal structure, and control structure of the horizontal trough mixer. Do not leave the work site during operation to prevent damage to the machine parts, so as to ensure safe production.

Second, horizontal trough mixer maintenance instructions

1. Regularly check the machine parts 1-2 times a month. Check whether the movable parts such as the worm gear, the worm, the bearing and the shaft seal are flexible and wearable. The defects should be repaired in time so that the groove mixer can be used normally.

2, machine parts lubrication: the lubrication of the reducer is oil-immersed, its oil storage must be maintained on the oil mark line, the oil quality must be kept clean. If it is used frequently, it must be changed every three months. When replacing, the gear unit should be removed and cleaned, and new oil should be added.

3. The control parts of the mixer electrical equipment should be kept clean and sensitive, and the fault should be repaired in time.

4. When using it once or when it is stopped, the remaining material in the mixing tank should be taken out and the residual powder in each part of the machine should be brushed. If the deactivation time is long, the trough mixer must be wiped clean and covered with a tarpaulin.

5. When the paddle is assembled and disassembled, it should be lightly disassembled, stabilized and lightly placed to avoid deformation damage.