Micro-spraying project to cultivate Ganoderma lucidum

(1) Black Shed's shading nets should be shaded at 85% with a black shading net. Shed type, according to the form of construction points: flat-top type, net shed was flat, shed 2.5 meters high; half slope type, net shed was "human" shape, under the net padding 6 meters wide film; full-arch type, net The shed is semi-circular, and it is lined with a 6-meter-wide film under the net, which resembles a small tunnel. According to the fixed material points: bamboo wood sheds, barbed wire sheds and plastic nylon net sheds.

(2) The micro-spraying project adopts the shading net must be combined with the supporting micro-jet engineering new technology, in order to better provide a good ecological environment for the growth of Ganoderma lucidum. The micro-spraying material is a bidirectional micro sprinkler. On a hard plastic pipe with a diameter of 10 mm, install a micro sprinkler every 1.2-1.5 m (to be installed at the same level, straighten the same horizontal pipe, do not undulate, twist), so that the water mist can be sprayed to the edge . When the water pressure at the end of the water pipe reaches 1.92X105-2.94X105, the droplet diameter is 0.2-0.4mm, and the spray uniformity is high, and the relative humidity of the air can quickly reach over 90%.

Installation can be based on the power of the natural level can be used to increase the difference (to be more than 8 meters) to install micro-spray pipe, can also use the water pump or submersible pump to carry out micro-spray.

(3) The production of short eucalyptus clinker-growing pouches The seasons in which the short eucalyptus cultivating bacteria are grown are not suitable for cultivating mycelium except for the July-August season, and they can be carried out in other seasons. It is best in Fujian from mid-November to late December or mid-February to late March. Both harvest 2-3 batches of fruiting bodies in the current year or the following year.

The tree suitable for cultivating Ganoderma lucidum is best suited for eucalyptus, mochi, lotus root and rice bran in the Fagaceae family. Sweet gum, casuarina, black peony, eucalyptus, poplar, etc. are also suitable.

The logs were cut into 12-15 cm short segments and packed in plastic bags 85 cm long and 65-75 cm wide. First, tie the short sections of wood into bundles with 14-gauge wire or bamboo rafts. The cross-sections at both ends must be flat. Each plastic bag can contain two layers of bundled sections.

Another approach is to cut a section of wood that is 30 centimeters long, 55-60 centimeters long plastic tube, one end twisted and folded into a bag, the bottom of the bag is first covered with wood chips 78%, bran 20%, sugar, Each 1% of the gypsum was formulated into a culture material, put into the section of wood, and then spread a layer of culture material, and tie the bag mouth with a thread.

After bagging, it was sterilized at atmospheric pressure and kept at 100°C for 12 hours. After sterilization, inoculate according to conventional methods. The strains of Ganoderma lucidum used in Songxi County were introduced from Japan by Xinzhou and Huizhou No.6 and Huizhou No.8. These strains are large, round, and high in yield and quality.

(4) After inoculation, the bacterium was cultured in the chamber, and the temperature was maintained at 25-30°C. Generally, 7-15 days, the mycelium is covered with a section of wood surface. After about 50 days, the mycelium grows to the inside of the section wood, and it can be moved into the black shed to remove the buried soil.

(5) Bacterial wood is used to manage the bacilli that are taken out of the bag and buried vertically (also recumbent) in the boring bed that has been prepared in the black shed. The bacteria is buried in the soil 2/3-3/4. Interval 8-10 cm, and then covered with a layer of 10 cm thick reedgrass or dry straw as a buffer layer, to prevent the splash of water when the mud splashed Ganoderma lucidum and prevent weeds and reduce the evaporation of soil moisture and other effects. In order to make Ganoderma lucidum thick, it is necessary to stay strong, leaving only 4-5 flowers for each bacterium. If two flowers are too close to each other, use bamboo and wood to gently open two stipes and let them become each other.

Greenhouse Drip Irrigation System

Fertigation is using your irrigator to fertilise the plants and soils as you water, which is the most efficient and advanced practice of fertilization. Aid of pressure system (or natural divide terrain), the soluble solid or liquid fertilizer, according to the soil nutrient content and crop fertilizer regularity and characteristics of species, with the fat of with irrigation water, through a controlled water supply pipeline system, supplying, the compatibility, water through the pipe and drop head form drip irrigation, uniform, regular, quantitative, infiltration area crop root growth and development, make the main root soil always stay loose and appropriate moisture content, at the same time according to different crop fertilizer characteristics, environment and soil nutrient content in soil; Crops in different growth phase water requirement, the different development stages of the fertilizer rule is the demand of design, the water and nutrient timing quantitative, provided directly in proportion to the crops.

Greenhouse Drip Irrigation System,Greenhouse Micro Irrigation System ,Plant Drip Irrigation

JIANGSU SKYPLAN GREENHOUSE TECHNOLOGY CO.,LTD , https://www.skyplantgreenhouse.com