How to install vertical worm gear reducer and horizontal worm gear reducer

How to install horizontal worm gear reducer and vertical worm gear reducer

The worm gear reducer adopts imported bearings, oil seals and lubricating oil. The worm gear is made of aluminum bronze. It greatly improves the service life of the reducer. It runs fairly smoothly, without noise, vibration and transmission efficiency. It can be divided into horizontal worm gear deceleration. Machine and vertical worm gear reducer, the two are different in installation.

Worm gear reducer

The vertical worm gear reducer is a vertical installation type, the input end is a connector connection (it can also be directly connected to the motor), the vertical installation type, and the output end is upward. The conventional speed reducer has a ratio of 1/10, 1/20, 1/30, 1/40, 1/50, 1/60, etc. This is a single-stage speed ratio, center distance (model) 50#~175#. According to the shaft output input WPA reducer has six directions of R, L, V, W, W1, F (please refer to the installation dimension specification table for details).

The horizontal worm gear reducer is a horizontal type, the input end is flanged (directly connected to the motor), horizontally mounted, and the output end is facing up. The conventional speed reducer has a ratio of 1/10, 1/20, 1/30, 1/40, 1/50, 1/60, etc. This is a single-stage speed ratio, center distance (model) 50#~175#. According to the shaft output input WPDO reducer has six directions of R, L, V, W, W1, F (please refer to the installation dimension specification table for details).

Hubei sailing reducer manufacturer, specializing in the manufacture of worm gear reducer, and provide related supporting products such as motor, clutch brake, etc., more installation methods and product consultation, you can contact us at any time.